Template:Infobox Glider

From Wikipedia, the free encyclopedia

Deletion of this deprecated or orphaned template has been suggested under the housekeeping speedy deletion criterion. If you are aware of any active uses of this template or believe it does not meet the criterion, please leave a message here.

{{{name}}}
 †[[Image:{{{image}}}|center|300px]]
 † {{{caption}}}
Name Qty
manufacturer   {{{manufacturer}}}
designer   {{{designer}}}
crew   {{{crew}}}
engine   † {{{engine}}}
span   {{{span}}}
wing area   † {{{area}}}
aspect ratio   † {{{aspect-ratio}}}
length of fuselage   † {{{length}}}
width at cockpit   † {{{width}}}
height at tail   † {{{height}}}
wing profile   {{{profile}}}
max. load   † {{{g-load}}}
empty weight   † {{{mass}}}
water ballast   † {{{ballast}}}
max. t/o weight   † {{{mtow}}}
max. load front seat   {{{pilot}}}
max. load rear seat   {{{copilot}}}
Vne   {{{vne}}}
Vs   {{{vmin}}}
Vra   {{{vra}}}
minimum sink rate   {{{minsink}}}
best glide ratio   {{{glideangle}}}

This Template is a first draft for a Infobox Glider.

Optional parameters are marked by a " †" in the right column. Parameters, which are left blank, will not be shown in the infobox.

This is an example, of a finished Infobox.


{{Infobox Glider|
 | name =  <Name>
 | image = † <Image>
 | caption = † <Caption>
 | manufacturer = <Manufacturer>
 | designer = <designer>
 | crew = <single / dual>
 | engine = <retractable>
 | span =  <span>
 | area = † <wing area>
 | aspect-ratio = † <aspect ratio>
 | length = † <length of fuselage>
 | width = † <width of fuselage at cockpit>
 | height = † <heiht at the tail>
 | profile = <wing profile>
 | g-load = † <max load>
 | mass = † <empty weight>
 | ballast = † <water balast in liter>
 | mtow = † <max. t/o weight>
 | pilot = <max load front seat>
 | copilot = <max load rear seat>
 | vne = <Vne>
 | vmin = <Vmin>
 | vra = <V rough air>
 | minsink = <minimum sink rate>
 | glideangle = <best glide ratio>
}}