Chi-square target models

From Wikipedia, the free encyclopedia

Chi-Square target models were introduced by Peter Swerling and are used to describe the statistical properties of the radar cross-section of complex objects.

Contents

[edit] General Target Model

Swerling target models give the RCS of a given object based on the chi-square probability density function, which has the following form:

p(\sigma) = \frac{m}{\Gamma(m) \sigma_{av}} \left ( \frac{m\sigma}{\sigma_{av}} \right )^{m - 1} e^{-\frac{m\sigma}{\sigma_{av}}}

σav refers to the mean value of sigma. This is not always easy to determine, as certain objects may be viewed the most frequently from a limited range of angles. For instance, a sea-based radar system is most likely to view a ship from the side, the front, and the back, but never the top or the bottom. m is the number of degrees of freedom divided by 2. While the number of degrees of freedom used in the chi-square probability density function is an integer value in statistics, it can assume any positive real number in the target model. Values of m between .3 and 2 have been found to closely approximate certain simple shapes, such as cylinders or cylinders with fins.

Since the ratio of the standard deviation to the mean value of the chi-square pdf is equal to m-1/2, larger values of m will result in less fluctuations. If m equals infinity, the target's RCS is non-fluctuating.

[edit] Swerling Target Models

Swerling target models are special cases of the Chi-Square target models with specific degrees of freedom. There are five different Swerling models, numbered I through V:

[edit] Swerling I

A model where the RCS varies according to a Chi-square probability density function with two degrees of freedom (m = 1). This applies to a target that is made up of many independent scatterers of roughly equal areas. As little as half a dozen scattering surfaces can produce this distribution. Swerling I describes a target whose radar cross-section is constant throughout a single scan, but varies independently from scan to scan. In this case, the pdf reduces to

p(\sigma) = \frac{1}{\sigma_{av}} e^{-\frac{\sigma}{\sigma_{av}}}

Swerling I has been shown to be a good approximation when determining the RCS of objects in aviation.

[edit] Swerling II

Similar to Swerling I, except the RCS values returned are independent from pulse to pulse, instead of scan to scan.

[edit] Swerling III

A model where the RCS varies according to a Chi-square probability density function with four degrees of freedom (m = 2). This PDF approximates an object with one large scattering surface with several other small scattering surfaces. The RCS is constant through a single scan just as in Swerling I. The pdf becomes

p(\sigma) = \frac{4\sigma}{\sigma_{av}^2} e^{-\frac{2\sigma}{\sigma_{av}}}

[edit] Swerling IV

Similar to Swerling III, but the RCS varies from pulse to pulse rather than from scan to scan.

[edit] Swerling V (Also known as Swerling 0)

Constant RCS (m \to infinity).

[edit] References

  • Skolnik, M. Introduction to Radar Systems: Third Edition. McGraw-Hill, New York, 2001.